Do not specify wireless interfaces as their names and behavior can be dynamic and unpredictable, instead assign wireless interfaces to bridges using the network option in wireless configuration. Physical interface name such as eth0.1, eth2, tun0 to assign to this section, or list of interfaces if type bridge is set. eth0), this will be down even if a cable is connected (with proto 'none' the interface is up). The result is that, if the interface section is mentioning a physical network interface (i.e. If an interface section has no protocol defined (not even none ), the other settings are completely ignored. Options marked as “yes” in the “Required” column must be defined in the interface section if the corresponding protocol is used, options marked as “no” may be defined but can be omitted as well. The corresponding options for each protocol are listed below. Unspecified protocol, therefore all the other interface settings will be ignored (like disabling the configuration)ĭepending on the used interface protocol several other options may be required for a complete interface declaration. VXLAN protocol for layer 2 virtualization, see here for further information and a configuration example IPv6-in- IPv4 tunnel for use with Tunnel Brokers like HE.net PPP over ATM - DSL connection using a builtin modemĬDMA, UMTS or GPRS connection using an AT-style 3G modem PPP over Ethernet - DSL broadband connection Static configuration with fixed address and netmaskĪddress and netmask are assigned by DHCPv6 _prefix= 'fd27:70fa:5c1d::/48'Īnd here the same settings as written in /etc/config/network # cat /etc/config/network Here an example network uci subsystem with default settings for a TL-WR1043ND: See also: Scripting interface Example network configuration To view all info about a particular interface (the UCI name not the physical interface), write: To see a list of interfaces write the following: In such a case it is required to run wifi up after ifup in order to re-establish the bridge connection. Note that wireless interfaces are managed externally and ifup may break the relation to existing bridges. Individual interfaces can be brought up with ifup name or down with ifdown name where name corresponds to the logical interface name of the corresponding config interface section.Īn ifup implies a prior ifdown so there is no need to invoke both when reloading an interface. Rebooting the router is not necessary, but is also another way that will force a configuration reload. Thanks to netifd (Network Interface Daemon), the changed interfaces will be restarted automatically to apply the changes live.
#SETTING STATIC IP FOR WIFI ON MAC NO INTERNET INSTALL#
If your install does not supply the service command, a reload can be accomplished with: This uci susbsystem is responsible for defining switch VLANs, interface configurations and network routes.Īfter any network configuration change (through uci or otherwise) you need to reload the network configuration in the netifd daemon by writing: The central network configuration is handled by the uci network subsystem, and stored in the file /etc/config/network.
0 kommentar(er)
